The data consists of 30 minute observations recorded by an automatic weather station (iWS 18) in Cabinet Inlet on Larsen C Ice Shelf on the Antarctic Peninsula. The iWS consists of a custom-built weather station unit, assembled at the Institute of Marine and Atmospheric research Utrecht (IMAU). There are sensors for air temperature, surface air pressure, relative humidity, as well as a GPS, an acoustic snow height sensor, an ARGOS communication antenna, and three Lithium batteries that fuel the unit when solar radiation is absent. The unit is complemented by a propeller-vane Young anemometer measuring wind direction and speed. Additionally, all radiation fluxes are measured with a Kipp and Zonen CNR4 radiometer. This dataset runs from 25 November 2014 to 13 November 2017. Funding was provided by the NERC grant NE/L005409/1.

Weather Research and Forecasting (WRF) model output for Larsen Ice Shelf run at 4km resolution. Modelling was carried out to support the Orographic Flows and the Climate of the Antarctic Peninsula (OFCAP) project during the 2010-2011 field season.

The data consists of 30 minute observations recorded by an automatic weather station (iWS 18) in Cabinet Inlet on Larsen C Ice Shelf on the Antarctic Peninsula. The iWS consists of a custom-built weather station unit, assembled at the Institute of Marine and Atmospheric research Utrecht (IMAU). There are sensors for air temperature, surface air pressure, relative humidity, as well as a gps, an acoustic snow height sensor, an ARGOS communication antenna, and three Lithium batteries that fuel the unit when solar radiation is absent. The unit is complemented by a propeller-vane Young anemometer measuring wind direction and speed. Additionally, all radiation fluxes are measured with a Kipp and Zonen CNR4 radiometer. This dataset runs from November 2014 to January 2017. Funded was provided by the NERC grant NE/L005409/1. ***** PLEASE BE ADVISED TO USE VERSION 2.0 DATA ***** The VERSION 2.0 data set (see ''Related Data Set Metadata'' link below) has an additional 10 months of measurements.

Automatic data loggers are often used to monitor environmental variables such as temperature (of air and soil), humidity, wind speed and radiation in microclimates where experimental or ecological studies are being carried out. Some loggers are only in operation for a few weeks or months while others have been run for several years. Loggers have been sited in a wide variety of locations from the sub-Antarctic (South Georgia), South Orkney Islands (Signy) various Peninsula sites (as far south as Alexander Island - 70S), and some continental localities (e.g. Victoria Land). These form an important data resource to the climate conditions experienced by Antarctic terrestrial organisms. Various types of logger are used. Sensors tend to be deployed at or near ground level and in and around particular types of vegetation, or other experimental sites, such as cloches. Loggers used include Grant, Delta-T, Campbell and Squirrels. Victoria Land data for Kay Island and Edmonson Point in 1995 and 1996 was collected under the BIOTEX 1 experiment of the SCAR BIOTAS (Biological Investigations of Terrestrial Antarctic Systems) Programme. An overview of BIOTEX is available as a PDF file.

The Weather Research and Forecasting (WRF) model output over the whole of Peru at 12 km horizontal resolution and 3 hourly output (domain 1, d01), the Rio Santa River Basin (in the Cordillera Blanca) at 4 km horizontal resolution and hourly output (domain 2, d02), the Vilcanota-Urubamba region at 4 km horizontal resolution and hourly output (domain 3, d03) and the upper region of the Rio Santa River Basin at 800 m horizontal resolution and hourly output (domain 4, d04). Domains 1 to 3 cover the period from 1980 to 2018, domain 4 covers from 2009 to 2018. Full details of the WRF model setup can be found in Fyffe et al., (2021). These data were corrected as part of the PEGASUS (Producing EnerGy and preventing hAzards from SUrface water Storage in Peru) and Peru GROWS (Peruvian Glacier Retreat and its Impact on Water Security) projects. The datasets were created to assess past climate in the Peruvian Andes, as a basis to determine future climate in the region, and as an input for glaciological and hydrological models. The data were created using the British Antarctic Survey high performance computer. The creation of this data was conducted under the Peru GROWS and PEGASUS projects, which were both funded by NERC (grants NE/S013296/1 and NE/S013318/1, respectively) and CONCYTEC through the Newton-Paulet Fund. The Peruvian part of the Peru GROWS project was conducted within the framework of the call E031-2018-01-NERC "Glacier Research Circles", through its executing unit FONDECYT (Contract No. 08-2019-FONDECYT).